15
LIGHTING SYSTEM, INSTRUMENTS
15.4
Setting the time
15.5
Resetting the service interval display
15.6
Checking the headlight setting
A
0 0 A
–
Do not activate the two buttons for approx. 15 seconds.
The display RPM 2 goes out and the set speed is stored.
Condition
The ignition is on.
The motorcycle is stationary.
–
Press the MODE button briefly and repeatedly until ODO appears on the display.
–
Press the MODE and SET buttons for 5 - 10 seconds.
The time display begins to flash.
–
Set the hours display using the MODE button.
–
Set the minutes display using the SET button.
–
Press the MODE and SET buttons for 5 - 10 seconds.
The time is set.
401303-01
Condition
The ignition is on.
The engine is switched off.
The motorcycle is stationary.
–
Press the SET button for more than 10 seconds.
Info
The service interval display can only be reset. It is not possible to individu-
ally adjust the distance or time to the next required service.
401358-01
–
Position the vehicle upright on a horizontal surface in front of a light wall and make
a mark at the height of the center of the low beam headlight.
–
Make another mark at a distance
Guideline
Distance
B
0 0 B
–
Position the vehicle vertically at a distance
low beam.
Guideline
400726-10
Distance
–
The rider, with luggage and passenger if applicable, now mounts the motorcycle.
–
Check the headlight setting.
The light-dark boundary must lie exactly on the lower mark when the motorcycle
is ready to operate with the rider mounted along with any luggage and a passen-
ger if applicable.
»
If the boundary between light and dark does not meet specifications:
–
Adjust the headlight range. (
under the first mark.
B
B
A
5 cm (2 in)
in front of the wall and switch on the
A
5 m (16 ft)
p. 78)
77