Removing The Brake Disc Of The Front Brake - KTM 125 Duke 2013 Repair Manual

12 WHEELS
12.4.3

Removing the brake disc of the front brake

(Duke EU/MAL)
–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
–
Clean and grease the shaft seal rings
Long-life grease (
–
Insert the spacers.
B01392-10
–
Clean the thread of the wheel spindle and screw
–
Position the front wheel and insert the wheel spindle.
The brake linings are correctly positioned.
–
Mount and tighten screw
Guideline
Screw, front wheel spindle
–
Insert wheel speed sensor
Guideline
Screw, wheel speed sensor holder
–
Mount and tighten screws
–
Take the motorcycle off of the front wheel stand. (
–
Pull the front brake and push down hard on the fork several times to align the
fork legs.
–
Tighten screws
Guideline
Screw, fork stub
B01391-11
Finishing work
–
Take the motorcycle off of the rear wheel stand. (
Preparatory work
–
Raise the motorcycle with the rear wheel stand. (
–
Raise the motorcycle with the front wheel stand. (
–
Remove the front wheel. (
Main work
(Duke COL)
–
Remove screws
–
Remove the brake disc.
304806-10
(Duke EU/MAL)
–
Remove screws
–
Take off the ABS sensor wheel and brake disc.
307349-10
Change the wheel bearing.
p. 270)
.
2
into the hole. Mount and tighten screw
3
.
5
.
6
p. 61)
.
1
.
1
and mating surfaces of the spacers.
1 A
.
2
M8 30 Nm
(22.1 lbf ft)
M6 8 Nm (5.9 lbf ft)
p. 11)
M8 15 Nm
(11.1 lbf ft)
p. 10)
p. 10)
p. 10)
63
.
4