Installing The Front Wheel; Removing The Brake Disc Of The Front Brake - KTM 690 Enduro R EU 2013 Repair Manual

13 WHEELS
13.6.2

Installing the front wheel

Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
13.6.3

Removing the brake disc of the front brake

–
Holding the front wheel, withdraw the wheel spindle. Take the front wheel out of
the fork.
Info
Do not pull the hand brake lever when the front wheel is removed.
Always lay the wheel down in such a way that the brake disc is not dam-
aged.
601809-10
–
Remove distance bushings
800080-10
–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
Replace the wheel bearing.
–
Clean and grease the shaft seal rings
bushings.
Long-life grease (
–
Insert the spacers.
800080-11
–
Position the front wheel and insert the wheel spindle.
The brake linings are correctly positioned.
–
Mount and tighten screw
Guideline
Screw, front wheel spindle
–
Activate the hand brake lever multiple times until the brake linings are in contact
with the brake disc.
601808-11
–
Remove the motorcycle from the lift stand. (
–
Pull the front wheel brake and push down hard on the fork several times to align
the fork legs.
–
Tighten screws
Guideline
Screw, fork stub
Preparatory work
–
Raise the motorcycle with the lift stand. (
–
Remove the front wheel. (
.
3
and bearing surface
1
p. 212)
.
2
.
3
p. 73)
of the distance
A
M24x1.5 45 Nm
(33.2 lbf ft)
p. 10)
M8 15 Nm
(11.1 lbf ft)
p. 10)
74