Table of Contents
Advertisement
7 8-26
1977 PONTIAC SERVICE MANUAL
SHlFTER SHAFT
0
DETENT
BALL
a
SLEEVE
m
SPRING
0
LOCK DETENT
P I N
BALL
2191
1-2 SHIFTER SHAFT
Fig. 78-22 Transmission Case Cover
-
Exploded View
11. Insert other detent ball into other end of interlock
sleeve and, while depressing ball, insert 1st-2nd shifter shaft
into cover and place it in second gear position.
12. Install shift forks, position new gasket on case (do
not coat with grease) and carefully position case cover
assembly into place, making sure shift forks are aligned with
their respective synchronizer sleeves.
K N O B / ' /
SHIFT
SHIFTER
FRONT
CONTROL
LEVER
LEVER
(REV.)
30LB.FT-
ASSY.
21 90
1
Fig. 78-23 Floor Shift Levers
13. Install case cover attaching bolts evenly to 18 lb. ft.
torque.
14. Install shifter levers, flat washers, lock washers and
nuts on shifter shafts. Torque nuts to 20 lb. ft.
15. Connect control rods to shifter levers, refill
transmission to proper level, check transmission operation
and adjust linkage as required.
SPEEDOMETER DRIVEN GEAR
Refer to procedure under 3-SPEED LT. DUTY
MUNCIE TRANSMISSION.
SHIFT CONTROL LEVER
-
R & R
(Fig. 78-23)
1. Release shift control lever by inserting a thin rule or
a piece of .015"-.02OV shim stock into socket along side base
of shift control lever on driver's side.
2. Insert rule or stock to depth of at least one inch to
unlock its bayonet retainer and lift control lever and tool up
out of shift socket.
3. Install shift control lever by inserting into shift socket.
Bayonet retainer will lock control lever automatically into
proper position.
Advertisement
Table of Contents
