Table of Contents
Advertisement
7A4-32
1 9 7 7 PONTIAC SERVICE MANUAL
Fig. 7A4-43 Removing Front Band
Fig. 7A4-44 Removing Sun Gear Shaft
TRANSMISSIONS
WITH
STEEL
SPEEDOMETER DRIVE GEAR
c. Installing Removers J 21427 and J 8433 and Bolt J
2 1904 on the output shaft, remove the speedometer drive gear
(Fig. 7A4-60).
d. Install a new steel speedometer drive gear and drive
to location approximately
5
21/32" from end of output shaft
to rear face of gear, using Spacer J 2 1028 (cup side up) and
Installer J 6133 (Fig. 7A4-61).
12. Remove output shaft-to-rear internal gear thrust
bearing and two (2) races.
13. Remove rear internal gear and mainshaft (Fig. 7A4-
62).
NOTE: Do not drop bearings.
D I A L INDICATOR
t
Fig. 7A4-45 Checking Rear End Play
Fig. 7A4-46 Removing Center Support Bolt
Fig. 7A4-47 Removing Intermediate Clutch Pack
15. Remove rear internal gear-to-mainshaft snap ring to
remove mainshaft.
14. Remove rear internal gear-to-sun gear thrust bearing
and two (2) races.
Advertisement
Table of Contents
