Installing Inner And Outer Stator Shaft Rear Bushings; Reaction Carrier Bushing; Direct Clutch Bushing; Transmission Reassembly - Pontiac TRANS AM 1977 Service Manual

7A2-44 1 9 7 7 PONTIAC SERVICE MANUAL
Fig. 7A2-100 Installing Inner and Outer Stator Shaft Rear
Bushings
Installation
.INPUT
RING G EAR
Using Tool J 23062-3 and Drive Handle J 8092, install
sun gear bushings to .010" below surface at either end (Fig.
7A2- 102).
REACTION CARRIER BUSHING
Removal
With reaction carrier properly supported, remove
bushing using Tool J 23062-3 and Drive Handle J 8092.
Installation
Using Tool J 23062-3 and Drive Handle J 8092, install
.
..
m .
- . A , , .
.
.
. . , .
Fig. 7 A 2 - 1 0 2 Installing Sun Gear Bushings
DIRECT CLUTCH BUSHING
Removal
With direct clutch drum properly supported, remove
bushing (Fig. 7A2- 103).
BUSH
DlREC
I
Fig. 7 A 2 - 1 0 3 Removing Direct Clutch Drum Bushing
Installation
Using Tool J 23329 and Drive Handle J 8092, install
direct clutch bushing (Fig. 7A2- 104).
TRANSMISSION REASSEMBLY
When servicing transmission, use only transmission fluid
or petroleum jelly as lubricants to retain bearings or races
during assembly. Lubricate all bearings, seal rings and clutch
.
.