Table of Contents
Advertisement
7A2-48
1 9 7 7 PONTIAC SERVICE MANUAL
Fig. 7A2-1 13 Detent Roller and Spring Assembly
10. Align lube holes in suction screen with those in valve
body and install screen gasket and screen.
NOTE: Be sure lube holes in screen match up with those
in valve body.
11. Install oil pan, using a new gasket. Tighten bolts to
130 Ib. in. in succession until bolts maintain torque
specification.
NOTE: If a new oil pan is being installed, transfer
production code number from right side of oil pan to new
pan.
GOVERNOR AND V A C U U M
MODULATOR
1. Install governor assembly, cover and
"0"
ring seal
and retainer wire (Fig. 7A2-114).
2. Install vacuum modulator valve.
3. Install vacuum modulator and retainer clip. Torque
bolts to 130 lb. in.
NOTE: Position retainer with tangs pointing toward
modulator.
1-2 ACCUMULATOR (FIG. 7A2-115)
1. Install 1-2 accumulator piston assembly.
2. Install accumulator spring.
3. Install new
" 0 "
ring seal in groove in case before
installing cover.
4. Install 1-2 accumulator cover compress cover and
install retaining ring.
INSTALL TRANSMISSION
Fig. 7A2-1 14 Governor Cover and
"0"
Ring Seal
--
FIG. 7A2-115 1-2 ACCUMULATOR ASSEMBLY
Before installing flex plate to coverter bolts, make certain
that the attaching lugs on converter are flush with flex plate
and converter rotates freely by hand in this position. Then,
hand start all three bolts and tighten finger tight before
torquing to specification. This will insure proper converter
alignment.
NOTE: After installation of transmission, lower and
remove vehicle from hoist. Check linkage for proper
adjustment.
Then installation of transmission is the reverse of remove
transmission with the following added steps:
Advertisement
Table of Contents
