Table of Contents
Advertisement
MANUAL TRANSMISSIONS
Fig. 7B-1 15 Installing Reverse and Reverse Idler Gears
FIRST AN
SXIFt
FIRST A ~ D
REVERY:
SHIFT LINK
Fig. 7B-1 1 6 Shift Forks andCinks
37. Install extension housing over output shaft, while
guiding selector lever to engage rail selector (Fig. 7B-123).
38. Install lipped needle thrust race (if used) with lip
toward front, needle thrust bearing and flat race over input
shaft (Fig. 7B- 124).
39. Install case to front side of center support and retain
with six (6) hex head bolts. Torque to 35 Ib. ft.
NOTE: If a binding condition exists when installing
case, check to be sure that a fifth speed gear spacer for
needle rollers did not fall down between fifth speed gear
and synchronizer.
40. Drive roll pin into shifter head and shift rail (Fig.
7B- 125).
NOTE: Coat plug threads with sealer number 1052080,
Loctite number 92 or equivalent.
41. Install mesh lock plunger, poppet spring and
threaded plug (Fig. 7B-126). Torque to 10 lb. ft.
NOTE: Coat pivot threads with sealer number 1052080,
Loctite number 92 or equivalent.
Fig. 7B-1 17 Installing First and Reverse Shift Fork to
Shift Rail
Fig. 7B-1 18 lnstalling First and Reverse Shift Fork and
Rail
Fig. 7B-1 19 lnstalling Synchronizer Hub Snap Ring
42. Line hole in selector lever with hole in extension
housing and install selector lever pivot (Fig. 7B-127). Torque
to 60 lb. ft.
Advertisement
Table of Contents
