Table of Contents
Advertisement
TURBO HYDRA-MATIC 2 5 0 TRANSMISSION
7A2-33
FIG. 7A2-70 DIRECT CLUTCH ASSEMBLY
-
EXPLODED VIEW
RETAINING RING
PRESSURE PLATE
r
DIRECT CLUTCH DRUM
l l
lr
Fig. 7A2-7 1 Removing Direct Clutch Pressure Plate
2. Remove sun gear to drive shell flat rear steel thrust
washer (Fig. 7 ~ 2 - 8 8 ) .
3. Remove sun gear assembly from drive shell.
,
4. Remove sun gear to drive shell front retaining ring
(Fig. 7A2-89). Discard retaining ring.
5. If bushing is to be replaced, refer to Bushing
Replacement Replacement Section.
l nspection
Check gear and sun gear shell for damage or wear.
Reassembly
1. Install new sun gear to drive shell front retaining ring.
Fig. 7A2-72 Removing Lined and Steel Clutch Plates
2. Install sun gear assembly into drive shell.
3. Install sun gear to drive shell rear flat steel rear thrust
washer.
4. Install new sung ear to sun gear drive shell rear
retaining ring.
NOTE: Do not stress front and rear retaining rings at
installation.
Advertisement
Table of Contents
