Table of Contents
Advertisement
9-1 8
1977 PONTIAC SERVICE MANUAL
-
:ABLE ADJUSTMENT PROCEDURE AT SERVO ASM.
I. SET CARBURETOR CHOKE TO "HOT IDLE" POSITION.
!.
WlTH CABLE INSTALLED TO MANIFOLD BRACKET SERVO
TO TEE
BRACKET & CARBURETOR LEVER, PULL SERVO END OF
CABLE TOWARD SERVO AS FAR AS I T WlLL GO.
1. I F ONE OF THE FOUR HOLES IN THE SERVO TAB THEN
LINES UP WlTH THE CABLE PIN, CONNECT PIN TO TAB WlTH
RETAINER.
I. I F A TAB HOLE DOES NOT LINE UP WlTH THE PIN, MOVE
THE CABLE AWAY FROM SERVO UNTIL THE NEXT CLOSEST
FRONT
TAB HOLE LINES UP AND CONNECT PIN TO TAB WlTH
RETAINER.
2AUTION
DO NOT STRETCH CABLE SO AS TO MAKE A PARTICULAR
TAB HOLE CONNECT TO THE PIN. THIS WlLL PREVENT
ENGINE FROM RETURNING TO IDLE.
SEE ADJUSTMENT
PROCEDURE FOR
PROPER HOLE
A & G SERIES
CABLE
CAUTION:
EMISSION HOSES IN
AREA MUST NOT BE
PINCHED BETWEEN
BRACKET AND A/C
A & G SERIES
CAUTION
DO NOT KINK CABLE
DURING INSTALLATION
/TO
TRANDSUCER
= b -
VIEW A
B, F, X SERIES ONLY
BRACE OR INTAKE
MANIFOLD BRACKET
MAN1 FOLD
TO INTAKE MAN1 FOLD
SERVO ASM. TO INTAKE MANIFOLD
CARB. LEVER
CABLE
CABLE TO CARB. LEVER
Fig. 9-1 7 Cruise Master Servo Mounting on Engine-"Y" V8, All Series
Advertisement
Table of Contents
