Table of Contents
Advertisement
7A4-30
1977 PONTIAC SERVICE MANUAL
Fia. 7A4-37 Removina Jam Nut and Manual Shaft
T H I ~ K N E S S
NOTCHES
ANDIOR NUMBER
,074-.078
None
1
,082-,086
1 Tab Side
2
,090-,094
2 Tab S ~ d e
3
,098-. 102
1 Tab O.D.
4
,106-.I I0
2 Tabs O.D.
5
114-,118
3 Tabs O.D.
6
12. Remove center support-to-case bolt, using a 3/8" 12
point thin wall deep socket (Fig. 7A4-46).
13. Remove intermediate clutch backing plate-to-case
snap ring.
14. Remove intermediate clutch backing plate, three (3)
composition and three (3) steel clutch plates (Fig. 7A4-47).
15. Remove center support-to-case retaining snap ring
(Fig. 7A4-48).
16. Remove entire gear unit assembly by lifting with
Holding Tool J 21795 with Hammer J 6125-1 (Fig. 7A4-49).
17. Remove output shaft-to-case thrust washer from rear
18. Place gear unit assembly, with output shaft facing
down, in hole in work bench or in Holding Fixture J 61 16
and Adapter J 21364.
19. Remove rear unit selective washer from transmission
case (Fig. 7A4-50).
20. Remove support-to-case spacer from inside of case
(Fig. 7A4-5 1).
21. Remove rear band assembly (Fig. 7A4-52).
DISASSEMBLY OF GEAR UNIT
of output shaft or f;om inside of case.
1. Remove center support assembly (Fig. 7A4-53)
Advertisement
Table of Contents
