Table of Contents
Advertisement
TURBO HYDRA-MATIC 3 5 0 TRANSMISSION
7A3-5 1
Fig. 7A3-126 Installing Square Cut 0-Ring Seal
lnstalling Parking Pawl and Actuating Rod
1. Install parking pawl, tooth toward the inside of case
(Fig. 7A3-127).
2. Install parking pawl shaft into case through
disengaging spring. Install disengaging spring on parking
pawl and slide shaft through parking pawl (Fig. 7A3-128).
3. Install parking pawl shaft retainer plug. Drive into
case using a 3/8" diameter rod, until retainer plug is flush
to .010" below face of case. Stake plug in three (3) places to
retain plug in case (Fig. 7A3-129).
4. Install park lock bracket and torque bolts to 29 lb. ft.
(Fig. 7A3- 130).
5. Install actuating rod under the park lock bracket and
parking pawl (Fig. 7A3-13 1).
Fig. 7A3-128 Parking Pawl Assembly
lnstalling Manual Shaft and Range Selector
Inner Lever
1. If a new manual shaft to case lip seal is necessary, use
a 7/8" diameter rod and seat flush with case (Fig. 7A3-132).
2. Install manual shaft through case and range selector
inner lever.
3. Install retaining jam nut on manual shaft. Torque jam
nut to 30 lb. ft. See Fig. 7A3-133. Install manual shaft to case
retainer.
lnstalling Intermediate Servo Piston, Check
Balls, Oil Pump Pressure Screen and Governor
Feed Screens
1. Install intermediate servo piston, apply pin, spring
seat (Fig. 7A3- 134).
Advertisement
Table of Contents
