Cruise Master Regulator & Servo Mounting-"Y", "P" And "Z", F Series - Pontiac TRANS AM 1977 Service Manual

9-20 1977 PONTIAC SERVICE MANUAL
ROUTE UNDER AIR
UPPER SPEED0 TO POWER UNIT
SHAFT ASM.
UPPER SPEEDO
TO INSIDE OF CAR
FENDER SKIRT SURFACE OF BRAKE PIPE ASM. TO TRANS. VALVE
CABLE ADJUSTMENT AT POWER UNIT.
1. SET CARBURETOR CHOKE TO "HOT IDLE"
POSITION.
2. WlTH
CABLE INSTALLED TO THROTTLE
BRACKET AND CARBURETOR LEVER, PULL
POWER UNlT END OF CABLE TOWARD POWER
UNlT AS FAR AS I T WlLL GO.
3. IF ONE OF THE FOUR HOLES I N THE POWER UNlT
TAB THEN LINES UP WlTH THE CABLE PIN,
CONNECT PIN TO TAB WlTH RETAINER.
4. IF A TAB HOLE DOES NOT LINE UP WlTH THE PIN,
MOVE THE CABLE AWAY FROM POWER UNlT
UNTIL THE NEXT CLOSEST TAB HOLE LINES UP
AND CONNECT PIN TO TAB WlTH RETAINER.
DO NOT STRETCH CABLE SO AS TO MAKE A
PARTICULAR TAB HOLE CONNECT TO THE PIN.
THlS WlLL PREVENT ENGINE FROM RETURNING
TO IDLE.
HEATER CASE ASM.
"P" AND "2" V-8's
NOTE: FOR "Y" V-8 SERVO SEE FIG. 9-17
SEE ADJUSTMENT PROCEDURE TAB-PART OF
FOR PROPER HOLE.
\
/
SNAP THlS TAB
OVER END OF PIN
I N DIRECTION OF
CABLE ASM. PIN ARROW.
INSTALLATION OF RETAINER
4059
Fig. 9-18 Cruise Master Regulator & Servo Mounting-"Y", "P" and "2". F Series