Installing Needle Thrust Bearing; Lnstalling Output Carrier Assembly; Lnstalling Input Ring Gear; Lnstalling Clutch Support Retainer Ring - Pontiac TRANS AM 1977 Service Manual

7A3-46 1977 PONTIAC SERVICE MANUAL
- . .-
Fig.
7A3-107
Installing Needle Thrust Bearing
Fig. 7A3-108 Ring Gear to Case Needle Bearing
lnstalling Output Carrier Assembly
1. Install output carrier assembly (Fig. 7A3-114).
2. Install input ring gear to output carrier needle thrust
bearing lip side face down.
3. Install output carrier to output shaft snap ring.
Use new snap ring and d o not overstress on installing.
USE PROPER SNAP R I N G PLIERS.
lnstalling Input Ring Gear
1. Install input ring gear (Fig. 7A3-115).
-
J
Fig.
7A3-109
lnstalling ~ e a c t i o n k a r r i e r Into Output Ring
Gear
Fig. 7A3-1 1 0 lnstalling Low and Reverse Clutch Plates
LOCATION . O F LOW AND REVERSE ROLLER CLUTCH W P P D R T
4902
TO CASE RETAINER SPRING
Fig.
7A3-1 11
lnstalling Clutch Support Retainer Ring
2. Install forward clutch housing to input ring gear front
thrust washer (Fig. 7A3-115). Washer has three (3) tangs.