Table of Contents
Advertisement
9-1 6
1 9 7 7 PONTIAC SERVICE MANUAL
FRONT
FILLER PLATE
TRANSDUCERCONN
CHAlN ADJUSTMENT .PROCEDURE
A. ASSEMBLE CHAIN TO BE TAUT WITH CARB. IN
THE HOT IDLE POSITION, AND WlTH THE IDLE
CONTROL
SOLENOID DE-ENERGIZED. PLACE
CHAlN INTO SWIVEL CAVITIES WHICH PERMIT
CHAlN
TO
HAVE
SLIGHT
SLACK.
PLACE
RETAINER OVER SWIVEL AND CHAlN ASSEMBLY.
RETAINER
MUST BE POSITIONED TO
REST
BETWEEN BALLS: VlEW 6. CUT OFF CHAlN FLUSH
WlTH SlDE OF SWIVEL TO REMOVE EXCESS
LENGTH. CHAlN SLACK NOT TO EXCEED ONE
HALF DIAMETER OF BALL STUD (.I501 WHEN
MEASURED AT HOT IDLE POSITION WlTH THE
IDLE CONTROL SOLENOID DE-ENERGIZED AND
SWIVEL DISCONNECTED FROM BALL STUD.
'SERVO UNIT
B. BALL SWIVEL MUST BE INSTALLED ON INBOARD
SlDE OF LEVER.
- & k X .
REF.
(RETAINER INSTALLED)
4
Fig. 9-15 Cruise Master Regulator & Servo Mounting-V6, B & X Series, Typical
Advertisement
Table of Contents
