Table of Contents
Advertisement
TURBO HYDRA-MATIC 4 0 0 AUTOMATIC TRANSMISSION
7A4-5 1
Fig. 7A4-106 Direct Clutch Housing
@4TEWDIATE CLUTCH
ROUfR YSEMBLY
1
DIRECT C L U T ~ H HOUSING
AND CAM ASSEMBLY
Fig. 7A4-109 lnstalling Intermediate Roller Assembly
I
W"'
-
Fig. 7A4-107 lnstalling Direct Clutch Center Seal
Fig. 7A4-1 10 lnstalling Outer Race
Fig. 7A4-108 lnstalling Direct Clutch Piston
CENTER SUPPORT
Disassemble (Fig. 7A4-113)
1. Check condition of the four oil seal rings and remove
from the center support if necessary.
2. Using your fingers, compress spring retainer and
remove snap ring (Fig. 7A4- 1 14).
3. Remove spring retainer and three (3) clutch release
springs.
4. Remove clutch release spring guide (Fig. 7A4- 1 15).
5. Remove intermediate clutch piston (Fig. 7A4-116).
6. Remove inner and outer piston seal.
NOTE:
Do not remove three (3) screws retaining
roller clutch inner race to center support.
Inspect Center Support
1. Inspect roller clutch inner race for scratches or
indentations. Be sure lubrication hole is open.
NOTE:
Be sure constant bleed plug orifice (approx.
.020 dia.) is open (Fig. 7A4-54).
2. Inspect bushing for scoring, wear or galling. If
replacement is necessary, proceed as follows:
Advertisement
Table of Contents
