Table of Contents
Advertisement
TURBO HYDRA-MATIC 350 TRANSMISSION
7A3-27
FORWA
CLUTCH
*
."
2829
Fig. 7A3-47 Removing Clutch Assemblies
Fig. 7A3-48 Removing Input Ring Gear
Removal of Low and Reverse Clutch Support
Assembly
1. Remove low and reverse roller clutch support to case
retaining ring (Fig. 7A3-5 1).
2. Grasp output shaft and pull up until low and reverse
roller clutch and support assembly clear low and reverse
clutch support retainer spring and remove support assembly.
3. Remove low and reverse clutch support retainer
spring (Fig. 7A3-5 1).
Removal and Reverse Clutch Plates
1. Remove five .(5) or four (4) low and reverse clutch
faced plates and five (5) or four (4) steel separator plates (Fig.
7A3-52).
Fig. 7 ~ 3 - 4 9 Removing Output Carrier Snap Ring
Fig. 7A3-50 Removing Drive Shell
Removal of Reaction Carrier Assembly
1. Remove reaction carrier assembly from output ring
gear and shaft assembly (Fig. 7A3-53).
;EMOVAL OF OUTPUT RING GEAR
rND SHAFT ASSEMBLY AND OUTPUT
llNG GEAR TO CASE NEEDLE
IEARING ASSEMBLY
Removal of Output Ring Gear and Shaft
Assembly
1. Remove output ring gear and shaft assembly from case
(Fig. 7A3-54).
2. Remove reaction carrier to output ring gear needle
thrust bearing.
3. Remove output ring gear to output shaft snap ring and
discard. Remove output ring gear from output shaft (Fig.
7A3-55).
Advertisement
Table of Contents
