Table of Contents
Advertisement
8-32
1977 PONTIAC SERVICE MANUAL
VIEW A
31 72
Fig. 8-46 X Series Instrument Panel Pad and Cluster Assembly
3. Remove radio control knobs, bezels and nuts, and
remove radio.
4. Remove screws at top and bottom of carrier securing
it to the IP pad and cowl brackets.
5. Disconnect shift indicator cable at shift bowl (if
automatic transmission), remove two (2) steering column to
IP nuts.
6. Lower steering column from IP and protect with shop
towel or tape.
7.
Disconnect speedometer cable from under dash.
8. Tilt carrier and cluster assembly forward, disconnect
printed circuit and cluster ground connectors, and all
remaining wiring.
9. Place carrier assembly on bench. Remove wire harness
and carrier assembly (4 screws) and set aside. Remove cluster.
10. To replace, reverse removal procedure.
H and H M Series (Figs. 8-48 and 50)
All instruments and gages can be replaced from front of
cluster in the normal manner after removing bezel and lens
as shown. If entire cluster carrier assembly must be replaced,
refer to Figures 8-48 and 8-50.
PRINTED CIRCUIT
All models except H are equipped with printed circuits
which supply current to most instrument panel lights and
instruments. These circuits are made of copper foil which are
Advertisement
Table of Contents
