Table of Contents
Advertisement
TURBO HYDRA-MATIC 3 5 0 TRANSMISSION
7A3-45
SEAL
4908
Fig. 7A3-103 lnstalling Piston Center and Inner Seals
Fig. 7A3-105 Compressing Low and Reverse Clutch
Fig. 7A3-104 lnstalling Low and Reverse Clutch Piston
2. Install reaction carrier to output ring gear needle
thrust bearing, with lip side face up ( ~ i ~ .
7~3-107).
3. Install output ring gear to case needle bearing
assembly (Fig. 7A3-108). Lip on inner race of bearing MUST
point toward rear of transmission.
4. Install reaction carrier assembly into output ring gear
and shaft assembly (Fig. 7A3-109).
5. Install output shaft and reaction carrier assembly into
case.
lnstalling Low and Reverse Clutch Plates
NOTE: Refer to specifications in rear of this section to
determine the required amount of lined and steel clutch
plates to use with specific transmission model and engine
combination. When replacing piston assembly, specific
part number must be used.
1.
Oil and install low reverse clutch steel separator plates
and faced plates, starting with a steel plate and alternating
with faced plates (Fig. 7A3-110).
Fig. 7A3-106 Output Ring Gear and Shaft Assembly
2. Install low and reverse clutch support retainer spring
-
-
.
-
(Fig. 7A3-111).
3. Install low and reverse clutch support assembly
pushing firmly until support assembly is seated past top of
low and reverse clutch support retainer spring so retaining
ring can be installed (Fig. 7A3-112).
Make certain the splines on inner race of the roller clutch
align with splines on reaction carrier.
4. Install low and reverse clutch support to case retaining
ring (Fig. 7A3- 1 1 1).
lnstalling Sun Gear Drive Shell Assembly
1.
Install low and reverse clutch support inner race to
sun gear drive shell thrust washer and install sun gear drive
shell assembly (Fig. 7A3- 1 13).
Advertisement
Table of Contents
