Installing A Pdu - Cisco ASR 14000 Series Installation Manual

How to Install or Remove the Power Components
Although there are differences between the different power module types (AC and DC), they are installed
Note
in the same manner.

Installing a PDU

This section describes how to install a PDU in the Cisco ASR 14000 series 8-slot line card chassis. For
information on the difference between the power types, see the
and the
and safety, see Regulatory Compliance and Safety Information for the Cisco ASR14000 Series
Aggregation Services Router.
The PDU is installed into the back of the chassis. After the PDU is installed, you can slide the power
modules into the chassis and connect them to the PDU to provide power to the chassis (see the
a Power Module" section on page 2-13
PDU types (AC Wye, AC Delta, and DC), they are installed in the same manner.
AC Wye PDU for reference.)
Figure 2-6
Prerequisites
Before performing this task, remove any front cosmetic covers.
Required Tools and Equipment
You need the following tools and part to perform this task:
•
•
•
•
Cisco ASR 14000 Series Router 8-Slot Line Card Chassis Installation Guide
2-10
"AC Power Systems" section on page
AC Wye PDU
ESD-preventive wrist strap
10-mm socket wrench
8-mm socket or open (box end) wrench
PDU
Chapter 2
"DC Power Systems" section on page 2-4
2-8. For complete information on regulatory compliance
for details). Although there are differences among the different
Installing and Removing Power Components
"Installing
(Figure 2-6
OL-16973-01
shows an