Cisco ASR 14000 Series Installation Manual page 92

How to Install or Remove an RP Card or DRP PLIM
For enhanced immunity to external electromagnetic disturbance levels of 10V per meter and 10 V RMS,
Note
you must use a shielded Ethernet (CAT5 or better STP) cable on the Management Ethernet connection
of the RP card (ASR14K-8-RP).
Figure 4-28 Route Processor (RP) Card for the 8-Slot Chassis
RJ-45 cable
Local terminal or
terminal server for
CLI communication
Remote terminal for
CLI communication
Remote CLI, CWI, XML,
or SNMP communication.
Remote file storage
Cisco ASR 14000 Series Router 8-Slot Line Card Chassis Installation Guide
4-40
RJ-45 cable
Ethernet cable
Network
Chapter 4 Installing and Removing MSCs, PLIMs, and Associated Components
Terminal connection
Console
Modem connection
AUX
ALARM
PID/VID
CRITICAL
MAJOR
MINOR
MGMT
Management Ethernet connection
ETH
for out-of-band network communication
CNTL
Optical Gigabit Ethernet for control
ETH 0
CNTL plane: (not user configurable)
ETH 1
PC
User-removable flash disk1
CARD
stores installation PIE files
A second internal flash disk0
stores installed software and
active configurations
EXT
CLK 1
EXT
CLK 2
LED status
displays
(alphanumeric)
Primary RP (on=primary)
Primary
Status
Card status (green=OK)
OL-16973-01