Installing Or Removing The Rear Side Exterior Components; Installing The Exhaust Grille - Cisco ASR 14000 Series Installation Manual

Installing or Removing the Rear Side Exterior Components

What to Do Next
Be sure that all parts have been carefully set aside and repackaged appropriately. If you have ordered the
optional cosmetic kit for the rear of the 8-slot chassis, proceed to the next section for instructions on
installing those components.
Installing or Removing the Rear Side Exterior Components
This section describes how to install or remove the optional exterior components for the rear of the Cisco
ASR 14000 series 8-slot line card chassis. This section contains the following sections:
•
•

Installing the Exhaust Grille

This section describes how to install the exhaust grille. The grille covers the power module and air intake
areas at the bottom of the rear side of the chassis, just below the card cage (see
Figure 5-5
Prerequisites
No prerequisites exist for this task.
Cisco ASR 14000 Series Router 8-Slot Line Card Chassis Installation Guide
5-8
Installing the Exhaust Grille
Removing the Exhaust Grille
Exhaust Grille
Chapter 5 Installing and Removing Exterior Components
Figure 5-5).
OL-16973-01