Cisco ASR 14000 Series Installation Manual page 85

Chapter 4 Installing and Removing MSCs, PLIMs, and Associated Components
Remove or install only one MSC at a time. Allow at least 15 seconds for the router to complete the
Caution
preceding tasks before removing or installing another MSC. The router may indicate a hardware failure
if you do not follow proper procedures.
Do not carry an MSC by the bracket attached to the faceplate.
Caution
Required Tools and Equipment
You need the following tools and part to perform this task:
•
•
•
Steps
To install an MSC, see
OL-16973-01
ESD-preventive strap
Medium flat-blade or Phillips screwdriver
MSC (Cisco product number ASR14K-MSC or ASR14K-MSC-B. See the product data sheet for
ordering details.)
Figure 4-24 and follow these steps:
Cisco ASR 14000 Series Router 8-Slot Line Card Chassis Installation Guide
How to Install or Remove an MSC
4-33