How To Install Or Remove An Msc; Installing An Msc - Cisco ASR 14000 Series Installation Manual

Chapter 4 Installing and Removing MSCs, PLIMs, and Associated Components
3.
4.
Switch Fabric Card Status LEDs
Use the status LEDs, located on the switch fabric card faceplate, to verify the correct installation of the
card:
•
•
•
•

How to Install or Remove an MSC

This section contains the following procedures:
•
•
•

Installing an MSC

This section describes how to install an MSC in the Cisco ASR 14000 series 8-slot line card chassis. For
more detailed information on the MSC, see Cisco ASR 14000 Series Router 8-Slot Line Card Chassis
System Description.
The MSC is a Layer 3 forwarding engine in the Cisco ASR14000 Series routing system (see
Figure
to provide a variety of interfaces.
There are two versions of the MSC: The original version (ASR-MSC) and Version B (ASR-MSC-B).
Both versions of the card provide the same functionality.
An MSC fits into any available MSC slot and connects directly to the midplane. If you install a new
MSC, you must first remove the MSC impedance carrier from the available slot.
OL-16973-01
Examine the alarm LEDs on the RP to see if there are any active alarm conditions.
Examine the power shelves to see whether the chassis, as a whole, is receiving power.
When the card is properly installed, the Status turns green. If this LED is off, verify that the card is
installed correctly.
When the Status is blinking yellow, a problem exists on the board.
When the Status is off, the board state is unknown. Verify that there is power to the board by looking
at the indicators on the power module.
If there is a failure during the board boot sequence, the two-row, four-character alphanumeric
display indicates the current boot phase to assist you in debugging the board failure.
Installing an MSC
Removing an MSC
Verifying the Installation of an MSC
4-23). An MSC can be paired with different types of physical layer interface modules (PLIMs)
Cisco ASR 14000 Series Router 8-Slot Line Card Chassis Installation Guide
How to Install or Remove an MSC
4-31