Cisco ASR 14000 Series Installation Manual page 66

How to Install or Remove a Slot Cover
Figure 4-12
Prerequisites
Before performing this task, remove any cosmetic covers and ensure that the slot over which you are
about to install the cover is empty. See the
the
Required Tools and Equipment
You need the following tools and part to perform this task:
•
•
•
Steps
To install a slot cover, follow these steps:
Attach the ESD-preventive wrist strap to your wrist and connect its leash to an ESD connection socket
Step 1
on the rear (MSC) side or a bare metal surface on the chassis.
Using the handle, hold the slot cover in place over the slot.
Step 2
Cisco ASR 14000 Series Router 8-Slot Line Card Chassis Installation Guide
4-14
Switch Fabric Slot (Half Height) Slot Cover
"Removing a Switch Fabric Card" section on page
ESD-preventive wrist strap
Large Phillips screwdriver
Slot cover
Chapter 4 Installing and Removing MSCs, PLIMs, and Associated Components
"Removing an RP or DRP Card" section on page 4-42
4-28.
and
OL-16973-01