Cisco ASR 14000 Series Installation Manual page 81

Chapter 4 Installing and Removing MSCs, PLIMs, and Associated Components
Prerequisites
Before performing this task, remove any front cover plates.
Removing more than one switch fabric card at a time can misalign the chassis and may damage the card
Caution
or chassis when reinserting the cards. Remove and reinsert only one card at a time.
Required Tools and Equipment
You need the following tools to perform this task:
•
•
Steps
To remove a switch fabric card, see
Figure 4-21 Removing a Switch Fabric Card
1
2
1 Captive screw
2
Ejector lever
OL-16973-01
ESD-preventive wrist strap
Large Phillips screwdriver
3
3
Figure 4-21 and follow these steps:
Direction of installation or removal
Cisco ASR 14000 Series Router 8-Slot Line Card Chassis Installation Guide
How to Install or Remove a Switch Fabric Card
4-29