Cisco ASR 14000 Series Installation Manual page 117

Chapter 5 Installing and Removing Exterior Components
Figure 5-3
Prerequisites
Before installing the inlet grille, you should mount the chassis in a rack and remove the rear handle pulls.
See Cisco ASR 14000 Series Router 8-Slot Line Card Chassis Unpacking, Moving, and Securing Guide.
Required Tools and Equipment
•
•
•
•
•
Steps
To install the inlet grille, follow these steps:
Remove the new inlet grille from its packaging, then set the packaging aside.
Step 1
Remove the AC rectifier power handles from their package.
Step 2
Attach the ESD-preventive wrist strap to your wrist and connect its leash to one of the ESD connection
Step 3
sockets on the front (PLIM) side of the chassis or a bare metal surface on the chassis.
If the old inlet grille is installed, remove the old inlet grille (see the next section,
Step 4
Grille").
OL-16973-01
Inlet Grille
ESD-preventive wrist strap
Inlet grille (Cisco product number: ASR14K-8-FRNT-GRILL=)
Number 1 Phillips screwdriver
Left AC rectifier power handle (Cisco product number: FABMTL,EXTENSION,PWR,L,HQ,HFR)
Right AC rectifier power handle (Cisco product number: FABMTL,EXTENSION,PWR,R,HQ,HFR)
Installing or Removing the Front Side Exterior Components
Cisco ASR 14000 Series Router 8-Slot Line Card Chassis Installation Guide
"Removing the Inlet
5-5