Removing A Switch Fabric Card - Cisco ASR 14000 Series Installation Manual

How to Install or Remove a Switch Fabric Card
What to Do Next
After performing this task:
•
•
•

Removing a Switch Fabric Card

This section describes how to remove a switch fabric card from the Cisco ASR 14000 series 8-slot line
card chassis. For more detailed information on the switch fabric card, see Cisco ASR 14000 Series Router
8-Slot Line Card Chassis System Description.
The switch fabric card is used only in single-chassis systems. The switch fabric card does not contain
any fiber-optic connectors because it is not connected to any other switch fabric modules (see
Figure
Figure 4-20
Cisco ASR 14000 Series Router 8-Slot Line Card Chassis Installation Guide
4-28
Place the impedance carrier in an antistatic bag for storage and future use.
Replace any front cover cosmetic plates and verify that the card has been installed properly (see the
"Verifying the Installation of a Switch Fabric Card" section on page
If you are performing the initial installation of the system, install the MSCs (see the
MSC" section on page 4-31).
4-20).
Switch Fabric Card
Chapter 4 Installing and Removing MSCs, PLIMs, and Associated Components
4-30).
"Installing an
OL-16973-01