Cisco ASR 14000 Series Installation Manual page 55

Chapter 4 Installing and Removing MSCs, PLIMs, and Associated Components
Information About Installing and Removing Cards and Associated Components
Figure 4-2 shows how to operate the ejector levers. Be sure to operate both levers simultaneously.
Figure 4-2 Operating Ejector Levers
When shipped, every slot in the chassis contains either an impedance carrier, or is covered by a slot cover
(see the "Information About Impedance Carriers and Slot Covers" section on page 4-6).
While it is not critical for you to install the cards in a certain order, following the card installation
Note
recommendations in this chapter will make your installation process easier.
Cisco ASR 14000 Series Router 8-Slot Line Card Chassis Installation Guide
4-3
OL-16973-01