Cisco ASR 14000 Series Installation Manual page 100

Chapter 4 Installing and Removing MSCs, PLIMs, and Associated Components
How to Install or Remove a Physical Layer Interface Module (PLIM)
Figure 4-32 Physical Layer Interface Module (PLIM)
The system may indicate a hardware failure if you do not follow proper procedures. Remove or install
Caution
only one PLIM at a time. Allow at least 15 seconds for the system to complete the preceding tasks before
removing or installing another PLIM.
Prerequisites
Before performing this task, remove any front cover plates.
Cisco ASR 14000 Series Router 8-Slot Line Card Chassis Installation Guide
4-48
OL-16973-01