Chapter 4
Installing and Removing MSCs, PLIMs, and Associated Components
How to Install or Remove a PCMCIA Card
This section contains the following procedures:
•
•
Installing a PCMCIA Card
This section describes how to install a PCMCIA card in an RP or a DRP card PCMCIA slot. For more
detailed information on PCMCIA cards, see the
section on page
Figure 4-30
the DRP are in a similar location.)
Note
Only disk1: can be installed in or removed from the ASR 14000 series 8-slot line card chassis route
processor.
Figure 4-30
RP Card PCMCIA Slot Door
1
PCMCIA flip-up door
Prerequisites
If you are replacing a PCMCIA card, see the
remove the PCMCIA card from the PCMCIA card slot.
Required Tools and Equipment
You need the following tools and part to perform this task:
•
•
•
Steps
To install a PCMCIA card, follow these steps:
OL-16973-01
Installing a PCMCIA Card
Removing an RP PCMCIA Card
4-12, or Cisco ASR 14000 Series Router 8-Slot Line Card Chassis System Description.
shows you the location of the PCMCIA door in the RP card faceplate. (The PCMCIA cards for
ESD-preventive strap
Medium flat-head screwdriver
PCMCIA card
"Information About Hard Drives and PCMCIA Cards"
1
"Removing an RP PCMCIA Card" section on page 4-46
Cisco ASR 14000 Series Router 8-Slot Line Card Chassis Installation Guide
How to Install or Remove a PCMCIA Card
CRS-16-RP
to
4-45