Removing The Exhaust Grille - Cisco ASR 14000 Series Installation Manual

Installing or Removing the Rear Side Exterior Components

Removing the Exhaust Grille

This section describes how to remove the exhaust grille (see
Prerequisites
There are no prerequisites for this task.
Required Tools and Equipment
You need the following tool to perform this task:
•
Steps
To remove the exhaust grille, follow these steps:
Attach the ESD-preventive wrist strap to your wrist and connect its leash to an ESD connection socket
Step 1
on the rear side or a bare metal surface on the chassis.
While facing the rear side of the chassis, firmly grasp the top outside edges of the exhaust grille.
Step 2
Pull the top of the grille firmly away from the chassis; it loosens from the connecting ball studs.
Step 3
Slide the hooks at the bottom of the grille free of the cutouts at the bottom of the chassis casing.
Step 4
Carefully set the exhaust grille aside.
Step 5
Cisco ASR 14000 Series Router 8-Slot Line Card Chassis Installation Guide
5-10
ESD-preventive wrist strap
Chapter 5 Installing and Removing Exterior Components
Figure 5-5 on page 5-8).
OL-16973-01