Removing A Power Module - Cisco ASR 14000 Series Installation Manual

Chapter 2 Installing and Removing Power Components
What to Do Next
After performing this task, you may connect the PDU to the power source (see the
section on page 2-4
"Before Powering the Chassis Up or Down" section on page

Removing a Power Module

This section describes how to remove a power module from the Cisco ASR 14000 series 8-slot line card
chassis. For information on the difference between the power types, see the
on page 2-4
compliance and safety, see Regulatory Compliance and Safety Information for the Cisco ASR14000
Series Aggregation Services Router.
The power module is located on the front of the chassis, and mates with the PDU that is installed on the
back of the chassis (see the
are differences among the power modules (AC Wye, AC Delta, and DC), they are installed in the same
manner.
Figure 2-9
1
2
1
2
Prerequisites
Before performing this task, remove any front cosmetic covers.
Required Tools and Equipment
You need the following tools to perform this task:
•
•
OL-16973-01
and the "AC Power Systems" section on page
and the "AC Power Systems" section on page
"Installing a PDU" section on page 2-10
(Figure 2-9 shows an AC Wye power rectifier for reference.)
AC Power Rectifier
OT
LLM
CB
AC
TMP FLT POW ER
FAIL
OK
3
Power switch
Module air filter
ESD-preventive wrist strap
Medium Phillips screwdriver
4
3 Handle
4
Captive screws
Cisco ASR 14000 Series Router 8-Slot Line Card Chassis Installation Guide
How to Install or Remove the Power Components
"DC Power Systems"
2-8) and power up the chassis (see the
2-8).
"DC Power Systems" section
2-8. For complete information on regulatory
for information). Although there
2-15