Reinstalling The Cable Management Bracket - Cisco ASR 14000 Series Installation Manual

Chapter 5 Installing and Removing Exterior Components
b.
Remove all screws on either side of the cable management bracket.
Step 3
For ease of removal, remove the outer screws first.
Tip
Caution
Set the bracket carefully aside.
Step 4
What to Do Next
You may now install a replacement cable management bracket, if necessary.

Reinstalling the Cable Management Bracket

The Cisco ASR 14000 series 8-slot line card chassis arrives preinstalled with a horizontal cable
management bracket on the front of the chassis and an optional horizontal cable management bracket
available for the rear of the chassis. The cable management system organizes the interface cables that
enter and exit the different cards, keeping them out of the way and free of sharp bends. If you need to
reinstall the cable management bracket, this section describes how to install that bracket in the chassis.
Caution Excessive bending of interface cables can damage the cables.
Figure 5-2
Prerequisites
Be sure that no cables impede your access to the area of the chassis on which you wish to install the
bracket.
OL-16973-01
The bezel is attached to the front of the chassis with four ball studs.
Pull the bezel firmly towards you to detach it.
Be careful not to damage the plastic bracket arms.
Cable Management Bracket
Installing or Removing the Front Side Exterior Components
Cisco ASR 14000 Series Router 8-Slot Line Card Chassis Installation Guide
5-3