Installing And Removing The Interface Module - Cisco ASR 920-24SZ-IM Installing

Installing and Removing the Interface Module

Figure 13: Mounting the Cisco ASR-920-24SZ-M, ASR-920-24TZ-M Router on the Wall
Caution
Caution
To install the drip tray for Cisco ASR-920-24SZ-IM Router, complete the following steps:
Step 2 Place the drip tray below the router as shown in the figure above.
Step 3
Tighten the four screws to affix the drip tray to the wall.
Installing and Removing the Interface Module
The sections describe the installation and removal of interface module on the Cisco ASR-920-24SZ-IM Router.
Installing the Router
14
When mounting the Cisco ASR 920-24SZ-IM, ASR-920-24SZ-M, ASR-920-24TZ-M Router
vertically, ensure that the power supplies are at the bottom.
When mounting the ASR-920-24SZ-1M to a wall, you must install the drip tray (Cisco part number
700-47267-01) as shown below to meet IEC 60950-1 product safety requirements.
Installing the Router