Removing Components Before Installing the Chassis
Required Tools and Equipment
Unpacking and Positioning the Router
Removing Components Before Installing the Chassis
Cisco XR 12410 Router Installation Guide
3-4
Before you begin the rack-mount installation, you must read and understand the
information in the
"Rack-Mounting Guidelines" section on page 2-6
following tools and equipment:
ESD-preventive wrist strap
•
•
Number 1 and number 2 Phillips screwdrivers
1/4-inch (6.35-mm) and 3/16-inch (4.5-mm) flat-blade screwdrivers
•
Tape measure
•
Level (optional)
•
A minimum of 10 slotted binderhead screws (usually provided with the rack)
•
to secure the chassis to the mounting flanges (also called rails) in the rack.
Five screws should be installed on each side of the chassis.
3/8-inch (10-mm) nutdriver (for systems equipped with the DC-input power
•
shelf)
9/16-inch (14-mm) wrench (for chassis hold-down bolts and pallet hold-down
•
bracket bolts)
3/4-inch (19-mm) socket and ratchet wrench
•
Follow the unpacking instructions shipped with the router and use a safety hand
truck to move the router to the location where it is being installed in a rack.
Save the packaging materials in case the router needs repackaging or shipping.
The router is designed to be lifted by two persons into a rack. To reduce the weight
of the system, you can remove some of the components before attempting to lift
it into the rack.
Chapter 3
Installing the Cisco XR 12410 Router
and have the
OL-13832-01