Nortel Remote Office 9150 Installation And Administration Manual page 94

Planning for installation
Remote Office 9150 unit
Installation checklist
Check Task
Gather the configuration information
(network addresses, connection numbers,
online/offline schedule, QoS thresholds, and
so on).
Install DSP application and trunk interface
modules into the Remote Office 9150 unit.
Choose a suitable location for the Remote
Office 9150 unit.
Install the Remote Office 9150 unit in the
chosen location.
Connect the Remote Office 9150 unit to the
power source, administration PC, and
network.
Power up the Remote Office 9150 unit and
observe LED behavior.
The Status LED remains lit when the power-
up cycle completes successfully.
Install the software from the product
CD-ROM or the Nortel Networks web site.
Configure the IP address, subnet mask, and
default gateway on the Remote Office 9150
unit.
68
For details, see
"Deployment options" on
page 97
Appendix B, "Planning
forms"
"Installing a trunk interface or
DSP application module" on
page 116.
"Choosing a suitable location"
on page 122.
"Mounting the Remote Office
9150 unit" on page 122.
"Connecting the Remote Office
9150 unit" on page 129.
"Powering up the Remote Office
9150 unit" on page 135.
"Installing the software" on page
138.
"Using the Configuration Wizard
to perform initial configuration"
on page 141.
Remote Office 9150
Standard 1.0
Page 2 of 4