Nortel Remote Office 9150 Installation And Administration Manual page 126

Planning for installation
4 Similarly, obtain the IP address assigned to the MIG RLC. This IP address
must be configured on the Remote Office 9150 unit, and is used by the
Remote Office 9150 unit to establish connections with the MIG RLC.
5 If IP mode is stage 2 in your network implementation, run this stage with a
minimal number of users until you are sure that
your IP network can handle the additional traffic
you can identify the kinds of configuration adjustments you need to
make to the IP network to handle that traffic
6
When you are satisfied with the IP network performance, continue with
implementing the QoS transitioning technology.
To implement the Quality of Service transitioning technology
When the QoS transitioning technology is implemented, calls transition
to the circuit-switched network when IP QoS degrades
back to the IP network when IP QoS returns to normal
1 To implement the QoS transitioning technology, you must understand what
your IP network is doing, such as
when the busy times are on the network
how much traffic is processed (during normal and busy traffic periods)
how to evaluate and adjust your network's Quality of Service
For more details, consult with your data network administrator and refer to
Appendix A, "Network engineering guidelines."
2 Once you have this information and understand it, determine what the QoS
settings should be, and then configure them on each MIG RLC port.
For instructions, refer to the Meridian Internet Gateway Reach Line Card
Installation and Administration Guide (NTP 555-8421-210).
3 If IP mode is the last stage in your network implementation, run this stage
with a minimal number of users until you are sure that your IP network's
Quality of Service is acceptable.
4 When you are satisfied with QoS transitioning performance, deploy the
QoS transitioning capability to the rest of the network.
100
Standard 1.0
Remote Office 9150