Remote Office 9150 Unit - Nortel Remote Office 9150 Installation And Administration Manual

Sample configuration files

Remote Office 9150 unit

Introduction
This section shows the configuration settings for the Remote Office 9150 unit.
You can obtain a similar configuration printout by performing a configuration
download while connected to the Remote Office 9150 unit.
Note: Configuration settings are separated by commas (,).
Configuration example
This configuration example uses the settings identified in the network diagram
shown on page 463.
IPCFG 10.1.1.2,255.255.0.0,10.1.1.10
APPMODCFG 0,SPARE,TSIDSP
APPMODCFG 1,E,G729,G729
APPMODCFG 2,NC,NC
APPMODCFG 3,NC,NC
APPMODCFG 4,1,1,E,1,1,5556987,60655569870101,E,1,1,
5556988,60655569880101
APPMODCFG 5,NC,NC
APPMODCFG 6,NC,NC
APPMODCFG 7,NC,NC
SYSCFG 2, Remote site 1
ROUCFG 13:00,0,JAN-13-2000,911,#222,#333,#345,#456,E
ACCFG N
472
9150 unit's IP interface information:
IP address
Subnet mask
IP gateway
On-board DSP module (module 0)
and installed DSP application
module (module 1)
ISDN BRI module configuration
module number
PSTN number for each B-channel
SPID for each B-channel
Unit ID and node name
System configuration:
Emergency service number
System date and time
SPRE codes
Standard 1.0
Remote Office 9150