Installing A Card - HP FlexFabric 11908-V Installation Manual

Figure 16 Attaching an ESD-prevent wrist strap (on a 11908-V)
(1) ESD wrist strap port (having an ESD sign)

Installing a card

Unless otherwise stated, MPUs, LPUs, and switching fabric modules are collectively referred to as "cards"
in this document.
All cards of the HP FlexFabric 1 1900 switches are hot swappable.
After all cards are installed, you can verify the running status of a card by referring to the card status LED
(SLOT) on the MPU of the switch. If the RUN LED blinks, the card in the slot operates correctly. For more
information about card status LED (SLOT), see
IMPORTANT:
Before installing a card to the chassis, make sure the connectors on the card are not broken or blocked
•
to avoid damaging the backplane.
• To ensure good ventilation, install a blank filler panel over an empty MPU, LPU, or switching fabric
module slot. MPU slots use the same type of blank filler panels as LPU slots.
"Appendix C LEDs."
21