Installing The Signal Conditioning Card; Interconnect Switch Removal; Removing The Cover Of An Interconnect Switch - HP Brocade 4Gb SAN Installation Manual

Installing the signal conditioning card

1. Power down the Interconnect switch.
2. Remove the Interconnect switch by releasing the latch (1 and 2 in
and sliding it out of the enclosure (3).
1
Figure 3

Interconnect switch removal

3. Remove the cover of the Interconnect switch by loosening the thumbscrews (see
Figure 4

Removing the cover of an Interconnect switch

24 Installing the 4Gb SAN Switch
2
Figure
3
3) on the front
Figure 4).