Table 9: System Information Page Parameters - Hn9400 Info Section - Hughes HN9400 Installation Manual

System Control Center
Table 9: System Information page parameters – HN9400 Info section
Parameter
Site ID
Serial number
Zipcode
Software Date
Software Release
LAN1 IP Address
LAN1 Subnet Mask
LAN1 MAC Address
Figure 64: System Information page
The parameters listed in the HN9400 Info section of the System Information page are explained
in the following table. Other sections of the screen (Transmit Radio Info and Satellite) provide
additional information about the router installation and the router software (Software
Configuration).
Identifies the site where the router is installed.
The router's serial number. The serial number may be required for
troubleshooting.
ZIP code of the router site.
Software build date.
Version of the router's software. This is typically the factory-installed
software version. However, if the NOC downloads a newer version
of Gateway software to the router, the newer version number is
displayed.
The satellite router address. The default router address is
192.168.0.1. A different router address can be configured.
Range of addresses available to the satellite router.
MAC address for the satellite router.
Explanation
HN9400 Satellite Router Installation Guide
1038554-0001 Revision B
Chapter 6
77