Conducting A Site Survey; Power Supply Information; Figure 3: Ac Power Supply For The Hn9400 Satellite Router - Hughes HN9400 Installation Manual

Preparing for installation

Conducting a site survey

Power supply information

Survey the customer site to confirm that the location meets the requirements for installation of
the satellite router. For complete site survey information, including site requirements, see the
Antenna Site Preparation and Mount Installation Guide (1035678-0001).
The key site survey tasks related to installation of the satellite router are:
1. Make sure there is an unobstructed line of sight to the satellite specified on the Installation
Reference Sheet.
2. Review the Installation Reference Sheet for site-specific instructions and the installation
specification for customer-specific instructions.
See also Connecting the power supply
The power supply is included in the satellite router shipping carton.

Figure 3: AC power supply for the HN9400 satellite router

Before proceeding, make sure you have the correct power supply. Check the part number on the
power supply and refer to Figure 3: AC power supply for the HN9400 satellite router
9.
• Always use the power supply provided with the satellite router. The router's performance
may suffer if the wrong power supply is used.
• Connect the AC/DC power supply to a three-wire, grounded outlet with an input of 110/240
VAC. A suitable surge protector is recommended to protect the satellite router from possible
damage due to power surges.
• Always connect the DC power cord to the HN9400 rear panel before applying power to the
power supply. If you apply power to the power supply and then connect the DC power cord,
the satellite router may not perform properly and could be damaged.
• Observe the power standards and requirements of the country where it is installed.
on page 19.
HN9400 Satellite Router Installation Guide
1038554-0001 Revision B
Chapter 2
on page
9