Powering Up The Router; Ac/Dc Power Supply; Dc/Dc Power Supply; Leds On Power-Up - Hughes HN9400 Installation Manual

Installing the satellite router

Powering up the router

AC/DC power supply

DC/DC power supply

LEDS on power-up

3. Connect the input power cable to the DC power source, but do not connect the input power
connector to the power supply at this time.
Do not connect the input power connector to the power supply until you are ready to observe
the router's LEDs upon power-up, as explained in
Check Power supply information
Follow these instructions to power up the router for the first time.
Prerequisites:
• The power outlet has been tested, as described in
page 19.
• According to previous instructions, the DC power cord is connected to the router's rear
panel, and the AC power cord is connected to the power supply.
1. Connect the AC power cord into the surge protector or wall outlet.
2. Observe the LEDs for proper operation. See
Prerequisites: The DC power cord is connected to the router's rear panel, and the input power
cable is assembled and connected to the DC power source.
1. Connect the input cable connector to the power supply.
2. Observe the LEDs for proper operation. See
As the router powers up, observe the front panel LEDs to make sure the router is working
properly. When power is applied to the router or after a router reset, the LEDs light up in the
following order, indicating normal power-up:
1. All LEDs light up for ½ sec while the router performs a self-test.
2. The Power LED lights up and remains on, indicating the router is powered up.
3. The Power LED and System LED light up for about 5 to 10 sec while the router loads and
prepares applications.
4. If the router LAN port is connected to a network device, the LAN LED lights up within 30
sec, indicating that LAN connectivity is detected.
5. The Power LED blinks, indicating that the router is not commissioned.
If the LEDs do not function as described, make sure you have the correct power supply. Refer
to Table 2: Power supply specifications for the HN9400 satellite router
LEDS on power-up
on page 9 to make sure you have the correct power supply.
Connecting an AC/DC power supply
LEDS on power-up
LEDS on power-up
HN9400 Satellite Router Installation Guide
1038554-0001 Revision B
Chapter 3
on page 21.
on
on page 21.
on page 21.
on page 10.
21