System Control Center
Transmission Information page
Parameter
Transmit Status
Number of Successful Transmissions
Number of Failed Transmissions
Number of Packets Submitted for
Transmission
Examining transmit status
The Transmission Information page shown in
page 75 displays information about data transmissions from the satellite router.
Figure 61: Transmission Information page
The parameters listed on the Transmission Information page are explained in the following table.
Table 8: Transmission Information page parameters
Indicates if the transmit data path is operational. Click the displayed
TxCode for explanation of the displayed code.
Number of frames transmitted to the satellite.
Number of frames that could not be sent. A continuously increasing
value indicates a transmission problem. If a low value is displayed
and does not increase, and the system is functioning, there is no
reason for concern.
Total number of data packets queued for transmission to the satellite
since the router was last restarted.
You can check the Transmit Status parameter to find out if the transmission data path is
operational or if there is a problem. Normal transmit status is indicated by the message
Transmitter ready. (TxCode 8).
The following two illustrations show how you can view a list of all TxCodes or see an explanation
of the currently displayed TxCode. Each TxCode—except TxCode 8—indicates a specific
problem in the transmission path.
Figure 61: Transmission Information page
Explanation
HN9400 Satellite Router Installation Guide
1038554-0001 Revision B
Chapter 6
on
75