Connecting The Satellite Router To The Customer's Computer; Verify That The Customer Can Browse The Internet; Figure 48: Connecting The Hn9400 To The Customer's Computer - Hughes HN9400 Installation Manual

Completing the installation

Connecting the satellite router to the customer's computer

Verify that the customer can browse the Internet

e) If the power source is DC, plug the input cable back into the power supply.
the power cord from the router's rear panel. Doing so could result in static electricity discharge
that could shock you and/or damage the router.
Use an Ethernet cable to connect the router to the customer's computer as shown in
Connecting the HN9400 to the customer's computer
the two LAN ports on the rear panel of the satellite router.

Figure 48: Connecting the HN9400 to the customer's computer

You (the installer) are required to stay at the installation site until the customer can connect to
the Internet so you can offer assistance if necessary.
After you have installed and registered the satellite router, verify that the customer can browse
the Internet. If the customer cannot browse the Internet:
1. Configure the installer laptop so its network properties match those of the customer's
computer.
2. Connect the installer laptop to the satellite router with an Ethernet cable.
3. Open a web browser on the installer laptop.
4. Try to access the router's System Control Center by typing in the browser's address bar:
www.systemcontrolcenter.com or 192.168.0.1.
Do not power cycle the satellite router by unplugging
on page 59. You can connect to either of
HN9400 Satellite Router Installation Guide
1038554-0001 Revision B
Chapter 5
Figure 48:
59