Connecting The Transmit And Receive Cables; Figure 5: Connecting The Transmit And Receive Cables To The Router - Hughes HN9400 Installation Manual

Installing the satellite router

Connecting the transmit and receive cables

Figure 4: HN9400 in vertical position
Connect the transmit and receive IFL cables to the satellite router.
1. Connect the transmit and receive cables to the connectors on the rear panel of the router as
shown in

Figure 5: Connecting the transmit and receive cables to the router

Figure 5: Connecting the transmit and receive cables to the router
tightened.
• Make sure each connector is properly aligned (not cross-threaded).
• The connector should be finger tight with no play.
The transmit and receive cable connectors must be securely
HN9400 Satellite Router Installation Guide
1038554-0001 Revision B
Chapter 3
on page 17.
17