Confirming That The Satellite Router's Files Are Up To Date; Figure 47: System Status Page - Hughes HN9400 Installation Manual

Chapter 5

Confirming that the satellite router's files are up to date

HN9400 Satellite Router Installation Guide
58
1038554-0001 Revision B
Use the System Control Center to confirm that the satellite router is operating with the most
current version of software.
1. Open a web browser such as Internet Explorer.
2. In the browser's address bar, type www.systemcontrolcenter.com or 192.168.0.1.
3. Press Enter.
The System Control Center home page appears in the browser window.
4. Click the System Status link.
The System Status page appears.

Figure 47: System Status page

5. Check the Software Download Status.
If it reads All files are up-to-date, the router has been commissioned.
6. Wait 15 minutes after completing registration for all files to be downloaded from the NOC
to the router.
7. If All files are up-to-date does not appear after 15 minutes, restart the router:
a) Go to the System Control Center home page.
b) In the Help section, click Restart HN9400.
8. If you do not see the All files are up-to-date message, power cycle the satellite router:
a) Unplug the power cord from the power source.
b) If the router is connected to a DC power source, unplug the DC input cable from the
router's power supply.
c) Wait 5 sec.
d) Plug the power cord back into the power source.
Completing the installation