Confirming The Receive Signal; Confirming The Transmit Signal; Figure 71: Reception Info Page; Figure 72: Transmission Info Page - Hughes HN9400 Installation Manual

Chapter 8

Confirming the receive signal

Confirming the transmit signal

HN9400 Satellite Router Installation Guide
90
1038554-0001 Revision B
To confirm that the router is properly receiving satellite signals:
1. At the System Control Center, click the Reception Info link.
The Reception Information page appears.
2. In the Receive Status field, check the RxCode.
If the RxCode is Receiver operational (RxCode 5) the router is receiving signals properly;
proceed to Confirming the transmit signal
If any other RxCode appears, the router is not receiving signals properly. Click the RxCode,
and follow the troubleshooting procedure that appears. Click the RxCode for explanation of
the problem and/or troubleshooting information.

Figure 71: Reception Info page

Note: The RxCode shown is an example.
To confirm that the router is properly transmitting signals to the satellite:
1. At the System Control Center, click the Transmission Info link.
The Transmission Information page appears.
2. In the Transmit Status field, check the TxCode.
If the TxCode is Transmitter Ready (RxCode 8) the router is transmitting signals properly;
proceed to Confirming that TCP Acceleration is operational
If any other TxCode appears, the router is not transmitting signals properly. Click the TxCode
for explanation of the problem and/or troubleshooting information.

Figure 72: Transmission Info page

on page 90.
on page 91.
Troubleshooting