Table of Contents
Advertisement
Commissioning the satellite router
Registering the satellite router
Figure 33: Manual cross-polarization warning message
The Cross Pol Test window displays the test status, isolation value, and pass/fail result.
Figure 34: Manual cross-polarization test results
5. Adjust the antenna during the manual cross-polarization test to achieve maximum transmit
isolation.
6. Lock down the antenna adjustment when the router consistently passes the manual
cross-polarization test.
7. Click Close to close the Cross Pol Test window.
8. On the Transmit Antenna Pointing screen, click Automatic to initiate the ACP test.
9. If the router fails ACP, re-peak the transmit isolation in manual cross-polarization test mode.
10. If the router passes ACP, click Close to close the Cross Pol Test window.
Ku-band pointing is now complete.
11. What you do now depends on whether you are using satellite-based or manual commissioning:
• If you are using satellite-based commissioning, click Next on the Transmit Antenna
Pointing screen to continue.
• If you are following the instructions for Ku-band manual commissioning, click Exit;
then go to
Software download—manual commissioning
To register the satellite router with the service provider's network, you select and access a
registration server.
To register the satellite router:
1. Click Next on the Transmit Antenna Pointing screen.
on page 55.
HN9400 Satellite Router Installation Guide
1038554-0001 Revision B
Chapter 4
45
Advertisement
Table of Contents
Troubleshooting
